the MIPS assembly language instructions to complete the following (in this order).  Remember that the data section of the program is stored in memory starting at the address 0x10010000. Use temporary registers ($t0-$t9) as needed. Do not change the values in registers $s0, $s1, or $s2 unless instructed.  Note: mem[0x10010000] means the memory at address 0x10010000.Actions:
1.        Initialize the register $s0 to 19
2.        Input a number and store it into register $s1
3.        Input a number and store it into register $s2
4.        Store the value in $s1 into mem[0x10010000]
5.        Store the value in $s2 into mem[0x10010004]
6.        Calculate the value of $s0 - $s1 + $s2 and store the result in mem[0x10010008]
7.        Print your name
8.        Print the following output each on its own line
  a.        The value in mem[0x10010000]
  b.        The value in mem[0x10010004]
  c.        The value in mem[0x10010008]  
9.        Exchange or swap the values in $s1 and $s2
10.        Exchange or swap the values in mem[0x10010004] and mem[0x10010008]
11.        Subtract 1 from the value in mem[0x10010000]
12.        Set the value in $s0 to ?$s0
13.        Print the following output each on its own line
    a.        The value in mem[0x10010000]
    b.        The value in mem[0x10010004]
    c.        The value in mem[0x10010008] 
14.        End the program using the correct syscall


도데체 명령어를 어떻게 알맞게 넣는지 전혀 모르겠어요 ㅠㅠㅠㅠ 전공이아닌데 들어서 하나도 모르겠어요 고수님들 제발좀 도와주세요!! 제발